Common problems and solutions of capsule filling machine

The capsule filling machine integrates machine, electricity and gas, adopts microcomputer programmable controller, touch panel operation, frequency conversion speed control, and is equipped with electronic automatic counting device, which can automatically complete the actions of capsule seating, separating, filling, locking, etc., reduce labor intensity, improve production efficiency, and conform to the requirements of pharmaceutical hygiene. This machine is sensitive in operation, accurate in filling dosage, convenient in operation, and suitable for filling all kinds of domestic or imported capsules. It is the economical and practical equipment for filling capsules in the pharmaceutical industry.

The following is a brief introduction to the capsule filling machine common problems and solutions, as follows:

1, screws loose, tighten the screws.

2, too much capsule shell inverted head (more than 3%), the vibrator is not properly adjusted, due to the adjustment of the appropriate voltage or capsule shell size is not in specification, the selection of qualified capsule shell.

3, the mold can not be reset in the track, the back end of the rail pressure spring stuck or capsule variant stuck. Reinstall the spring or the top bar, the other will push the stick will be stuck capsule pushed down.

4, the mold in the guide plate wear and tear, affecting the capsule set of low rate, replace the new mold or the two sides of the positioning of the loose, tighten the positioning nails, capsule deformation or wet, replace the good capsule shell.

5, the vibration is not ideal, adjust the voltage.

6, the capsule shell row good in the worktable, the mouth is high or low, adjust the height of the misalignment plate and guide rail.

7, the capsule shell stuck in the table plate can not fall, replace the capsule shell or adjust the position of the misalignment plate and the table plate hole.